Kellermann Blinker Bullet 1000 Extreme black

Bullet 1000 Extreme with clear glass

Made in Germany
ECE approved for front and rear
Useable on all vehicles (e.g.. B. Quad, Car, SUper Seven, Trailer, etc.)
Special flashing effect
Unique homogeneous light ring
Extreme light output
HPT - Homogenous Projection Technology
Kellermann HighPower LED Technology
Long Life Protection Guard®, IC controlled, 330 kHz clocked
High-quality metal housing
Suitable for 12 volt vehicle electrical systems
With M8 x 20 mounting thread
Europe-wide protected design

Classic meets high-tech

With the Bullet 1000, the aim was to redefine the classic bullet shape via the clear Kellermann design and to equip it with the most modern electronics. A highlight of the product is the newly developed lighting technology (Kellermann-HPT), which enables a homogeneous, ring-shaped beam and sets new standards. Because design quality does not end with the product shape and the product surface, but is also defined by the light emitted. The high-quality processed metal housing with a maximum diameter of 39 mm appears discreetly as a piece of jewellery on the motorcycle and is available in the surface variants chrome, black as well as matt chrome. The Bullet 1000 therefore fits any sophisticated bike design. The Bullet 1000 is available in 3 technology variants: extreme turn signal, turn signal with yellow position light and turn signal with brake/rear light.

Bullet 1000 Extreme

The Bullet 1000 Extreme is the pure turn signal with high luminosity, which has an approval according to ECE-R 6 for all types of vehicles. The advantage for motorcycle conversion is that the Bullet 1000 Extreme may be mounted closer to the headlight than any conventional motorcycle turn signal, opening up additional possibilities in the design of the motorcycle conversion. Like the Bullet 1000 PL, the Bullet 1000 Extreme offers the typical LED fast response** on the outer ring and combines it with a smooth response on the inner luminous surface. This gives the flashing signal a harmonious effect and fits in perfectly with the overall impression of the product.

- A load-independent relay or power resistors may be required to adjust the flashing frequency.
- Combination of IC controlled LONG LIFE PROTECTION GUARD® circuit with high power LEDs of latest design.